• October 29, 2021

How to make a Disney movie with a 3D printer

This post contains affiliate links.

Read our disclosure policy for more details.

How to make your own Disney movie in 3D?

I know I would love to make my own Disney film and I have done some research on how to do this.

There are a few different ways to do it though, so I will give you a little guide on how I would do it.

In short, the key is to get a 3DS camera, a 3d printer, a laser printer and a printer to print out a film.

I have included the 3D print directions below for you to follow.

Step 1: Get your 3D camera.

I bought mine from Amazon, as it was the cheapest.

If you are looking for a cheaper model, the Canon Rebel T2i is also available.

If this is not your favourite, there is also the Panasonic GH5 which is cheaper.

Step 2: Get the 3d print directions.

Step 3: Go to a local 3D printing store.

Step 4: Open your printer.

Step 5: Press the Print button.

Step 6: Go through the print sequence.

Step 7: Once you have finished, go back and print the movie out.

It will look something like this.

Step 8: Save your film.

Step 9: Download your film onto your computer.

You can download a movie as an MPEG file or as an XBM file, which means that it will play on a PC.

Step 10: Import the film into a 3ds print.

I will show you how to import a movie onto a 3DPrinter and how to download it onto your 3ds printer, so that you can download it on a computer or download it to your 3DS print.

You will need to do all this on your 3d printed 3ds film.

I am using a 3dpb file to print this.

I have printed the film in the above sequence, but I have also printed it in a smaller printable version, which you can see in the picture above.

The 3DPb file is a very useful tool if you are trying to make something that you do not have on hand, because it allows you to print the film without cutting or sanding it.

If you do have on the go, I recommend using a digital camera, because you will be able to print all of the details on your film in one print, as opposed to having to buy and sand a lot of your own film.

You should also make sure you are printing in a resolution that is good for the size of the printer.

If all of this sounds too complicated, then you might want to go to a 3DI shop.

I also have used 3DPB prints to make 3D models, and that is an awesome tool if it works out for you.

Step 11: Download the movie into your 3DP3D printer.

I did not use the 3DPprint, but if you do then you can check out the 3dsprint tutorial.

Step 12: Upload the movie to your printer and print it out.

If everything goes well, you should have something like the picture below.

I hope this article has been useful for you, if not, you can always ask me in the comments or leave a comment below and I will make sure I get your question answered!